Installation Instructions

1) Aach mounng strap[A] to outlet box[B] using the two (2) strap
mounng screws[C]. The mounng strap can be adjusted to suit
posion of xture.
2) Grounding instrucons: (See Illus. I or II).
a) On xtures where mounng strap is provided with a hole and
two raised dimples. Wrap ground wire from outlet box around
green ground screw, and thread into hole.
b) On xtures where a cupped washer is provided. Aach ground
wire from outlet box under cupped washer and green ground
screw, and thread into mounng strap.
If xture is provided with ground wire. Connect xture ground wire
to outlet box ground wire with wire connector (not provided) aer
following the above steps. Never connect ground wire to black or
white power supply wires.
GREEN GROUND
SCREW
CUPPED
WASHER
OUTLET BOX
GROUND
FIXTURE
GROUND
DIMPLES
WIRE CONNECTOR
OUTLET BOX
GROUND
GREEN GROUND
SCREW
FIXTURE
GROUND
I
II
Fixture Diagram
Parts List
[A] Mounting Strap
[B] Outlet Box
[C] Strap Mounting
Screws
[D] Mounting
Screws
[E] Canopy
[F] Socket Ring
[G] Glass
Installaon Instrucons
Cauons
CAUTION – RISK OF SHOCK –
Disconnect Power at the main circuit breaker panel or main
fusebox before starng and during the installaon.
Warning:
This xture is intended for installaon in accordance
with the Naonal Electrical Code (NEC) and all local code
specicaons. If you are not familiar with code requirements,
installaon by a cered electrician is recommended.
B
E
G
A
C
D
F
3) Make wire connecons. Reference chart below for correct
connecons and wire accordingly.
Connect Black or Red
Supply Wire to:
Connect White Supply Wire to:
Black White
*Parallel cord (round & smooth) *Parallel cord (square & ridged)
Clear, Brown, Gold or Black
without Tracer
Clear, Brown, Gold or Black
with Tracer
Insulated wire (other than
green) with copper conductor
Insulated wire (other than
green) with silver conductor
*Note: When parallel wire (SPT 1 & SPT
2) are used. The neutral wire is square
shaped or ridged and the other wire
will be round in shape or smooth
(see illus.)
Neutral Wire
4) Push xture to wall. Be sure not to pinch wires between wall and
canopy of xture. Note: xture can be mounted with the glass in the
up or down posion.
5) Screw in two (2) mounng screws[D]: one on top of canopy[E] and
the other into the boom of canopy.
6) Carefully raise glass to the xture. Slip the smaller opening over the
socket and t the glass[G] against the socket cover.
7) Thread socket ring[F] onto socket. Tighten socket ring to secure glass
in place. (DO NOT over ghten.)
8) Repeat for remaining sockets (if necessary).
9) Insert recommended bulb(s) (not supplied).
Installaon Instrucons (connued)