Assembly Instruction

Table Of Contents

6 7

4 5

Cleaning & Care

Attach Ring (E) to Upper/Lower

Tube (A) &

(B) and align the holes of Ring (E) with the upper

holes of Upper/Lower

Tube (A) & (B), then

firmly tighten with Bolt (J) using Allen Wrench (N).

Put the assembled stool base up-side -down on

Upper Frame (F), align holes of Swivel (D) with the

holes of Upper Frame (F) and firmly tighten them

with Bolt (H), Spring Washer (L), Metal Washer(M)

using Allen Wrench (N).

Attach Seat Cushion (G) to Upper Frame (F) with

Screw (K), firmly tighten with stool (Not provided),

then turn the barstool upright.

It is recommended to tighten all bolts every 3

months.

Stand chair up on an even surface and check that it

is balanced. If there is a slight wobble, apply

downward pressure in the corner where a leg is

uneven. Keeping pressure in that corner, tighten all

bolts. If balanced, apply downward pressure evenly

in the center and tighten all bolts. Do not over-tighten

beyond hole depth.

Treat surface with care. Surface is resistant to scratches but is not scratch resistant. Clean surfaces with a

dry or damp soft cloth. Do not use abrasive cleaners. Hardware may loosen over time. Periodically check that

all connections are tight.

Helpful Tip:

-Instead of applying downward

pressure while reachingunder

to tighten bolts,have someone

sit in the chair while you tighten

the bolts.

Not provided