Assembly Instruction

ManualsBrandsThree Posts ManualsBlack Console TablesNewquay 50'' Console Table

ASSEMBLY INSTRUCTION

This page lists all the contents included in the box.

Please take the time to identify the hardware as

well as the individual components to this product.

As you unpack and prepare for assembly, place

the contents on a carpeted or padded area to

protect them from damage.

A B C D

I J

F G H

Top Panel

Allen Wrench

1PC

2PCS2PCS 12PCS 6PCS

1PC 2PCS 1PC 1PC

HandlesTension Bar

Bolts

1/4”x1-3/8”xØ13

Bolts

1/4”x1/2”xØ16

Bolts 3/16”x1/2”

Nut Spanner Wrench

Lower Panel (L) Side Frame (R) Side Frame

5PCS 1PC 1PC

M N

Wood Screws

4 x 25 x 6mm

2PCS

Wall Anchors

Mounting Tabs

Plastic Mounting

Straps

2PCS 4PCS 2PCS

RUSTIC ELEGANT DETAILED LEG STORAGE TV STAND

Summary of content (4 pages)

PAGE 1
ASSEMBLY INSTRUCTION RUSTIC ELEGANT DETAILED LEG STORAGE TV STAND A B Top Panel 1PC E 2PCS I Allen Wrench Wood Screws 4 x 25 x 6mm 2PCS G Handles J 5PCS N Bolts 1/4”x1-3/8”xØ13 2PCS 1PC H Bolts 1/4”x1/2”xØ16 6PCS L Nut Spanner Wrench 1PC O Wall Anchors (R) Side Frame 12PCS K Bolts 3/16”x1/2” D 1PC 2PCS 1PC M (L) Side Frame 2PCS F Tension Bar C Lower Panel Mounting Tabs 1PC P Plastic Mounting Straps 4PCS This page lists all the contents included in the box.
PAGE 2
***Do not tighten screws & bolts until the entire unit is completely assembled. 1 Use the Philips Screwdriver (not provided) to loosen the screws and remove the MDF boards from the Top Panel (A). Attach Handles (F) to the front panel of drawers with Bolts (G) as shown. A G F 2 Attach Left Side Frame (C) and Right Side Frame (D) to Lower Panels (B) using Bolts (G) and Allen Wrench (I) .
PAGE 3
Attach the Side Frames (C&D) to Top Panel (A) with Bolts (H) as shown. Attach Tension Bars (E) to the back of Side Frames (C&D) using Screws (J) and Philips Head Screwdriver (not provided). Then secure MIDDLE using Screw (J) and Nut (K). Attach Mounting Tabs (O) to the bottom of Top Panel (A) with Bolts (H) as shown.
PAGE 4
*NOTE: WE RECOMMEND THAT YOU ATTACH THE PRODUCT TO YOUR WALL AS A SAFETY PRECAUTION. Drill 2 (Two) holes in your wall approximately 2” (Two Inches) BELOW the corresponging positions of Mounting Tabs (O) and insert Plastic Sockets (N) as shown. *NOTE: You may need to tap LIGHTLY with a rubber mallet. Attach Mounting Tabs (O) to Plastic Mounting Straps (P) with Wood Screws (M), making sure the Tabs extend UPWARD.