Owner Manual

2of2
NOTE: ALL DIMENSIONS ARE ROUNDED
UP TO THE NEAREST 1/4"
NOTE: TWO LIGHTS SHOWN FOR
ILLUSTRATION PURPOSES ONLY.
FINISH: OLD BRONZE/
BRUSHED NICKEL
through the Canopy Lock Ring (FF) and the Ceiling Canopy (II) in
order.
C. Attach one end of the Fixture Chain (GG) to the Fixture Loop (A)
with one Quick Link (HH). Lift the fixture and Fixture Chain (GG) up
and attach the other end of the Fixture Chain (GG) onto the Canopy
Chain Loop (EE) with another Quick Link (HH). The fixture will now
hang safely. Close the chain loop at the Ceiling Canopy Loop (EE).
D. Feed the Supply Wires and Ground Wire through the Canopy Chain
Figure 4
PART NUMBER
1
NO.
PART NUMBER
REPLACEMENT PART
REQ.
2
G3642SH
GLASS
3
M2374CHOZ
CHAIN
1
Loop (EE) and Nipple (DD) into
the Outlet Box. Cut the wires
leaving approximately 8” of
wire extending from the Outlet
Box.
E.RefertoStep5forwire
connections.
F. Raise the Ceiling Canopy (II)
and Canopy Lock Ring (FF) up
the Fixture Chain (GG) and
over the Canopy Chain Loop
(EE). Tighten the Canopy Lock
Ring (FF) onto the Canopy
Chain Loop (EE) until tight.
Suggested chain length for
Ceiling height :
8’ ceiling : use 14 links of chain
9’ ceiling : use 23 links of chain
10’ ceiling : use 32 links of
chain
5” Dia.
22” Dia.
8” Dia.
5”
16.5”
69” Overall Height
Includes 48” Chain()
1
2
3
3
I1101EC VINTAGE BULB
3
(3)Medium Base
Decorative
Filament 60W
bulbs (provided),
Maximum 100W.
1
M381CHBN
CHAIN
1
DD
GG
EE
FF
II
A
Supply
Wires and
Ground Wire
HH
HH
Figure 5
STEP 5 - Wire Connections
A. Use standard wire connectors (not included) to make all wire
connections. (Connectors are not included with fixture.) Twist
connectors until wires are tightly joined together. Wrap each
connection with approved electrical tape and carefully stuff all the
connected wires into outlet box.
Note: If the electrical wire is going to be cut shorter than provided
you will need to identify the "L" line wire and the "N" neutral wire
before you cut the excess wire off. One is labeled N and the other
labeled L. To do this separate the "L" line wire and the "N" neutral
wire as far as you need to. Re-label the wire near where you want to
make the cut. Be sure to mark the wire on the side of the fixture and
not on the excess wire being cut and removed.
White wire
from supply
Ribbed side of wire from fixture
identified with the Label “N”
Black wire from
supply (or Red)
Smooth side of wire from fixture
identified with the label “L”
Ground wire
from supply
Ground wire
from fixture
STEP 6 - Install Shade and Bulb
A. Place the Shade (D) over the socket
and secure with the Socket Collar (E).
Hand tighten until snug.
B. This fixture uses Medium Base
Decorative Filament 60W bulb (F),
Maximum 100W. Insert bulb and
screw snugly into place.
Your fixture is now assembled and
ready to use. Enjoy!
Figure 6
Socket
D
E
F