Owner Manual

Step 12
P
ae 17
å
Unfold the SMALL BACK (I2) and lay it over the bottom of your unit.
å
Diaram 1. Place the SMALL BACK (I2) into the edes of the LOWER ENDS (C2 and D2), with the bottom ede of the
SMALL BACK (I2) even with the bottom surface of the BOTTOM (F). There should be a ap between the top ede of
the SMALL BACK (I2) and the bottom ede of the LARGE BACK (H3).
å
Diaram 2. To fasten the bottom ede of the BACK (I2), place the o set ede of the Nail Holder down aainst the
BOTTOM (F). Place a NAIL into the nail slot of the Nail Holder. Tap the nail throuh the BACK and into the ede of
the BOTTOM (F). Remove the Nail Holder from the NAIL and completely tap the NAIL in with your hammer. Finish
fastenin the BACK to the BOTTOM with the hammer and Nail Holder placin NAILS approximately 5-1/2" apart.
å
Diaram 3. To fasten the side edes, place the bead of the Nail Holder down between the SMALL BACK (I2) and the
LOWER LEFT END (D2) 1-1/2" from the corner. Place a NAIL (1N) into the nail slot of the Nail Holder. Tap the NAIL
throuh the BACK and into the lower ede of the LOWER LEFT END. Remove the Nail Holder from the NAIL and
completely tap the NAIL in with your hammer. Finish fastenin the BACK to the LOWER LEFT END with the hammer
and Nail Holder placin NAILS approximately 5-1/2" apart. Repeat this process for the LOWER RIGHT END (C2).
å
Diaram 4. Fasten the remainin edes of the LARGE BACK (H3) and SMALL BACK (I2) to the SHELF (G3). Use three
BLACK 7/8" LARGE HEAD SCREWS (17S). Evenly space the screws as shown. The SCREWS will not o throuh the
BACKS, but they will fi t in the ap between the BACKS.
å
NOTE: There are no pre-drilled holes in the SHELF (G3). Use extra force when turnin these screws.
NAIL
(22 used in this step)
1N
Unfi nished
surface
H3
I2
F
D2
Nail Holder
4.
3.
Bead
512"
1.
Lower ede
C2
G3
2.
O set ede
These edes
must be even.
BLACK 7/8" LARGE HEAD SCREW
(3 used in this step)
17S
Nail slot
112"