Owner Manual

Step 11
Pae 16
å
We have provided a Nail Holder tool to use in this step for proper
positionin of the NAILS. Please refer to the parts of the Nail Holder
as the bead, o set ede, and nail slot as shown in Diaram 1.
å
Unfold the LARGE BACK (H3) and lay it over the top of your unit.
å
Diaram 2. Place the LARGE BACK (H3) into the edes of the UPPER ENDS (A3
and B3), with the top ede of the LARGE BACK (H3) even with the top surface of the TOP (E3).
å
Diaram 3. To fasten the top ede of the BACK (H3), place the o set ede of the Nail Holder down aainst
the TOP (E3). Place a NAIL into the nail slot of the Nail Holder. Tap the nail throuh the BACK and into the ede
of the TOP (E3). Remove the Nail Holder from the NAIL and completely tap the NAIL in with your hammer. Finish
fastenin the BACK to the TOP with the hammer and Nail Holder placin NAILS approximately 5-1/2" apart.
å
Diaram 4. To fasten the side edes, place the bead of the Nail Holder down between the LARGE BACK (H3) and the
UPPER LEFT END (B3) 1-1/2" from the corner. Place a NAIL (1N) into the nail slot of the Nail Holder. Tap the NAIL throuh
the BACK and into the lower ede of the UPPER LEFT END. Remove the Nail Holder from the NAIL and completely tap the
NAIL in with your hammer. Finish fastenin the BACK to the UPPER LEFT END with the hammer and Nail Holder placin
NAILS approximately 5-1/2" apart. Repeat this process for the UPPER RIGHT END (A3).
Do not stand the unit upriht without the
BACK fastened. The unit may collapse.
Caution
NAIL
(26 used in this step)
1N
Unfi nished
surface
H3
B3
A3
E3
These edes
must be even.
4.
Nail slot
Bead
512"
2.
Lower ede
3.
O set ede
Bead
Nail slot
Nail
Holder
O set ede
1.
112"