Owner Manual

ASSEMBLY
STEP 1
1. Attach 2 Cam Lock Pins 2 to Back D into guide holes.
2. Align and insert Cam Lock Pins on Back D into pre-drilled holes on Dividers E .
( Note: please pay close attention to the location of the 2 small guide holes which
accommodate the lid support. They need to be on the same side as the holes of
cross hinges .)
3. Place 2 Cam Locks 2 into pre-drilled holes on Dividers E .
4. Use a flathead screwdriver to tighten Cam Locks into Pins.
This Side Up
7/13