Installation & Assembly

Table Top

This page lists all the contents included in the box.

Please take the time to identify the hardware as

well as the individual components to this product.

As you unpack and prepare for assembly, place

the contents on a carpeted or padded area to

protect them from damage.

1 pc

Legs

4 pcs 4 pcs

Flat Washer

∅1/4"x19x1.5mm

Lock Washer

∅1/4"

Allen Key

4mm

Shelf

1 pc

8 pcs 8 pcs 1 pc

Allen Bolt

∅1/4"x45mm

Screw

∅8x32mm

8 pcs

A B C D

E F G H

PAGE 1
A Table Top B Legs 1 pc E Allen Bolt ∅1/4"x45mm 8 pcs 4 pcs F Lock Washer ∅1/4" 8 pcs C Shelf 1 pc Washer G ∅Flat 1/4"x19x1.5mm 8 pcs D ∅Screw 8x32mm 4 pcs Key H Allen 4mm 1 pc This page lists all the contents included in the box. Please take the time to identify the hardware as well as the individual components to this product. As you unpack and prepare for assembly, place the contents on a carpeted or padded area to protect them from damage.
PAGE 2
1 Attached three Legs(B) to the Table Top(A). Use Allen Bolt(E) Lock Washer(F) and Flat Washer(G) on holes of Table Top(A). Turn the Allen Key(H) in Allen Bolt(E). A 2 Attached Shelf(C) to the Leg(B). Use Screw(D), on holes of Shelf(C). Attached the rest Leg(B) to the Table Top(A). Use Allen Bolt(E) Lock Washer(F) and Flat Washer(G) on holes of Table Top(A). Tighten the Allen Bolt(E) on Leg(B).
PAGE 3
Take out the drawer, and remove the handle at back side of drawer. Use bolt install the handle on front side. Cleaning & Care Treat surface with care. Surface is resistant to scratches but is not scratch resistant. Clean surfaces with a dry or damp soft cloth. Do not use abrasive cleaners. Hardware may loosen over time. Periodically check that all connections are tight.