Installation & Assembly

Turn on the power at fuse or circuit box.
1. Turn off the power at the fuse or circuit box before starting installation.
2. Loosen the wire connector connected with the wires from photocell. (See Fig.3)
Note: Do not remove the photocell to prevent water from seeping into the outlet box.
3. Take a white pigtail and black pigtail and make wire connections using wire connector (C): (See Fig.4)
a. The black wire from the fixture to one end of the black pigtail.
b. The white wire from the fixture to one end of the white pigtail.
c. The other end of the black pigtail to the black wire from the power source.
d. The other end of the white pigtail to the white wire from the power source.
Put all wires back into the backplate of the fixture.
Photocell
White Wires From Photocell
Wire Connector
Wires From Fixture
White Pigtail
Red Wires From Photocell
Black wires From Photocell
Fig.3
Wires From Fixture
Wires From
Main Power
Wire Connector (C)
Pigtail
Fig.4
Turn on the power at fuse or circuit box
3. Pull out the source wires from the outlet box. Make wire connections using wire connectors (C) as follows:
• Connect the hot wire (usually black insulation) from the fixture to the black wire from the power source.
• Connect the neutral wire (usually white insulation) from the fixture to the white wire from the power source.
• Attach the fixture grounding wire (usually green insulation or bare wire) to the mounting plate unit (A) with
the green grounding screw, then connect it to the house grounding wire with the wire connector (C).
Carefully put all of the wires back into the outlet box.
4. Attach the backplate of the fixture to the mounting plate unit (A) by aligning holes,
secure the two set screws (D) and two rubber pads (E) from the side hole of the
backplate into the hole of the mounting plate unit (A).
Note: With silicone caulking compound, caulk completely around where the
backplate meets with the wall surface to prevent water from seeping into the
outlet box.
5. Gently insert the glass panels into the top notches of fixture, then press the bottom
clips to secure the glass panels. (See Fig.1 and Fig.2)
6. Install bulb (not included). See relamping label at socket area or packaging for
packaging for maximum wattage allowed.
Optional Installation: Disconnect Dusk-to-Dawn Photocell
IMPORTANT:
Compatible with dimmer when photocell is disconnected.
* Requires dimmable bulb and compatible dimmer switch.
Glass Panel
Fixture
Bottom Clip
Fig.1
Glass Panel
Fixture
Top Notch
Fig.2