Owner Manual

ASSEMBLY AND MOUNTING INSTRUCTIONS

Please read the Assembly lnstruction sheet carefully before proceeding. Carefully unpack

and

identify all parts prior to building the unit. Each part is identified on the drawing for reference.

DO NOT DISCARD THE ORIGINAL PACKAGING. If after careful inspection and you must return the

item for any reason. Please repack the unit using the original carton and inner box

STEP 1: Unpack all the parts and

classify them according to the

illustration shown at the side. Place the

parts on a scratch free surface.

STEP 2: Install the glass panels into the

frame and fix it using the clips.

STEP 2: lnstall the Loop to the Fixture.

STEP 4: lnstall the correct bulbs(not

provided).

STEP 5: Buckle the chain to the fixture

and loop.

STEP 6: Make sure the power is turned

off at the ceiling junction box where the

fixture is to be installed. Secure the

mounting bracket to the junction box

using the outlet box screws.

STEP 7: Use the wire connector to

connect the positive and negative wires.

Connect the ground wire to the junction

box ground port.

STEP 8: Secure the canopy to the

ceiling Junction box using the threaded

ring.

Turn on the power at fuse or circuit box.

Socket

Nipple

PAGE 1
ASSEMBLY AND MOUNTING INSTRUCTIONS Please read the Assembly lnstruction sheet carefully before proceeding. Carefully unpack and identify all parts prior to building the unit. Each part is identified on the drawing for reference. DO NOT DISCARD THE ORIGINAL PACKAGING. If after careful inspection and you must return the item for any reason. Please repack the unit using the original carton and inner box STEP 1: Unpack all the parts and classify them according to the illustration shown at the side.