Installation & Assembly

Table Of Contents

Cleaning & Care

Put the assembled chair up-side-down on Upper Frame (F). Align holes of Swivel (D) with the holes of

Upper Frame (F) and firmly tighten them with Bolt (H), Spring Washer (L) and Metal Washer(M),

using Allen Wrench (N).

Attach Seat Cushion (G) to Upper Frame (F) with Screw (K), firmly tighten with stool (Not provided), then turn

the chair upright.

Stand chair up on an even surface and check that it

is balanced. If there is a slight wobble, apply

downward pressure in the corner where a leg is

uneven. Keeping pressure in that corner, tighten all

bolts. If balanced, apply downward pressure evenly

in the center and tighten all bolts. Do not over-tighten

beyond hole depth.

Treat surface with care. Surface is resistant to scratches but is not scratch resistant. Clean surfaces with a dry or

damp soft cloth. Do not use abrasive cleaners. Hardware may loosen over time. Periodically check that all connections

are tight.

Helpful Tip:

-Instead of applying downward

pressure while reachingunder

to tighten bolts,have someone

sit in the chair while you tighten

the bolts.

Not provided