Installation & Assembly

ManualsBrandsThree Posts ManualsAll Bar Stools & Counter StoolsAbrams Quarter Cross Back Adjustable Height Swivel Bar Stool

Table Of Contents

EDCBA

JIHGF

ASSEMBLY INSTRUCTION

This page lists all the contents included in the

box. Please take the time to identify the

hardware as well as the individual components

to this product. As you unpack and prepare for

assembly, place the contents on a carpeted or

padded area to protect them from damage.

Upper 'U' Tube Leg ExtensionLower 'U' Tube Swivel Ring

Upper Frame

1/4”, 12mm 1/4”, 18mm

Seat Cushion Bolt Bolt

1/4”, 32mm

Bolt

1 pc 1pc 4pcs 1pc 1pc

1 pc 1pc 8pcs 4pcs 4pcs

4 pcs 8pcs 8pcs 1pc 4pcs

ONMLK

Screw

3/16”, 28mm

Spring Washer Metal Washer Allen Wrench Foot Pad

(Spare Part)

Summary of content (4 pages)

PAGE 1
ASSEMBLY INSTRUCTION A Upper 'U' Tube 1 pc F Upper Frame A B Lower 'U' Tube A Leg Extension C 1pc G Seat Cushion 4pcs H Bolt K Screw 1pc L Spring Washer E Ring 1pc I Bolt 1/4”, 12mm 1 pc D Swivel 8pcs J Bolt 1/4”, 18mm M Metal Washer N Allen Wrench 8pcs 1pc 8pcs 1/4”, 32mm 4pcs 3/16”, 28mm 4 pcs 1pc 4pcs O Foot Pad (Spare Part) 4pcs This page lists all the contents included in the box.
PAGE 2
1 (For 29 inch seat height chair) Insert Leg Extension (C) into the bottom of Upper/Lower 'U' Tube (A) & (B). Make sure Leg Extension (C) hole is aligned with the holes of Upper/Lower 'U' Tube (A) & (B), insert Bolt (H) into the lower holes, and firmly tighten using Allen Wrench (N). ***Take the Allen Wrench, and turn the bolts until the legs are secure. DO NOT TIGHTEN COMPLETELY. Stop when you feel you are adding force to tighten the bolt.
PAGE 3
4 Turn the Swivel (D) 45 degrees (as picture shown) for easy assembly. Then put it on Upper/Lower'U' tube (A) & (B), align the holes and firmly tighten with Bolt (I), Spring Washer (L) and Metal Washer (M) using Allen Wrench (N). Attach Ring (E) to Upper/Lower 'U' Tube (A) & (B) and align the holes of Ring (E) with the upper holes of Upper/Lower 'U' Tube (A) & (B), then firmly tighten with Bolt (J) using Allen Wrench (N).
PAGE 4
5 Put the assembled chair up-side-down on Upper Frame (F). Align holes of Swivel (D) with the holes of Upper Frame (F) and firmly tighten them with Bolt (H), Spring Washer (L) and Metal Washer(M), using Allen Wrench (N). N H L M D D F F 6 Attach Seat Cushion (G) to Upper Frame (F) with Screw (K), firmly tighten with stool (Not provided), then turn the chair upright. Not provided Stand chair up on an even surface and check that it is balanced.