Assembly Instructions

Remark: The mounting plate(s) are only to be used if you have your own standard side rail frame(s).

Steps:

Use Bolt(J) with Lock Washer(K), Flat

Washer(L), and Plastic Washer(M) to connect

Mounting Plate(I) onto Headboard Panel(A), by

5mm Allen Wrench(U).

Then, use the Bolt(R) with the Locker

Washer(O), Flat Washer(P), Plastic

Washer(M), and Flat Washer(P), Locker

Washer(O), Nut(S) to tighten the Side Rail(E)

with the Mounting Plate(I) by Open Wrench(V)

Use Bolt(J) with Lock Washer(K), Flat Washer(L), and Plastic Washer(M) to connect Side Rail(E)

onto Headboard(A) and Footboard Panel(C), by 5mm Allen Wrench(U).

Use Sunk Bolt(Q) to tighten the Support Leg

(G) onto Slat(F), by 4mm Allen Wrench(T).

Make sure the Slat(F) are properly tenoned

onto Side Rail (E).

Cleaning & Care

Treat surface with care. Surface is resistant to scratches but is not scratch resistant. Clean

surfaces with a dry or damp soft cloth. Do not use abrasive cleaners. Hardware may loosen

over time. Periodically check that all connections are tight.