Assembly Instructions

1
Turn the Headboard Panel (A) upside down and place it on a piece of cloth to prevent from scratching. Attach Headboard
Leg (B) to the Headboard Panel (A). Insert JCBC Bolt (H), Spring Washer (L) and Flat Washer (K) to the holes and tighten using
Allen Key (N).
2
Treat surface with care. Surface is resistant to scratches but is not scratch resistant. Clean surfaces with a dry or damp soft
cloth. Do not use abrasive cleaners. Hardware may loosen over time. Periodically check that all connections are tight.
CLEANING & CARE
2
Attach Side Rail (G) to Headboard (A) and Footboard (C) by inserting JCBB Bolts (J) loosely into provided holes, then hook
Side Rail brackets on as shown. Tighten all bolts using Allen Key (O).
4
Spread the Slats (D) and place it to the Side Rail (G). Tighten the Slats (D) with CSK Screw (M) using Philip Head Screwdriver
(Not provided).
A
G
G
C
G
C
A
D
N
H
L
K
8x
(Do not tighten
the bolt)
8x
(Tighten all the
bolt at this step)
J
J
O
O
M
Open the Slats (D) with bottom facing up. Place Slats Support (E) and Slats Support Leg (F) on top of Slats (D). From bottom
of Slats (D) insert JCBC Bolt (I) to the holes and tighten using Allen Key (N).
Repeat the same process to the other set of Slats (D).
3
N
I
44x
F
D
E
F
4x
8x
Back of Headboard
A
B
B
12x (Center of Slat)
16x (Right of Slat)
16x (Left of Slat)