Installation & Assembly
12
17
11
14
1. OUTLET BOX (NOT INCLUDED)
2. CROSS STRAP
3. OUTLET BOX SCREW and WASHER
(pre-attached to outlet box)
4. BLACK SUPPLY WIRE (not included)
5. SMOOTH (or BLACK) FIXTURE LEAD WIRE
6. WHITE SUPPLY WIRE (not included)
7. RIBBED (or WHITE) FIXTURE LEAD WIRE
8. FIXTURE GROUND WIRE
9. SUPPLY GROUND WIRE (not included)
10. WIRE CONNECTOR
11. DECORATIVE NUT
12. GLASS SHADE
13. SOCKET RING
14. COVER PLATE
15. GROUND SCREW (pre-attached)
16. FIXTURE SCREW and HEX NUT
(pre-attached)
17. SOCKET
2-LIGHT VANITY / 3-LIGHT VANITY
13
Please read carefully and save these instructions, as you may need them at a later
date.
Turn off the main power at the circuit breaker before installing the fixture in order to
prevent possible shock.
All electrical connections must be in accordance with local and National Electrical Code
(N.E.C.) standards. If you are unfamiliar with proper electrical wiring connections obtain the
services of a qualified electrician.
Remove all parts and hardware from the box and make sure that none are missing by
referencing the illustrations provided.
1. Remove CROSS STRAP (2) from the fixture. Secure the CROSS STRAP (2) to the OUTLET
BOX (1) (not included) with existing OUTLET BOX SCREWS and WASHERS (3).
2. Attach the BLACK SUPPLY WIRE (4) to the SMOOTH (or BLACK) FIXTURE LEAD
WIRE (5) with WIRE CONNECTOR (10). In the same manner, attach the WHITE SUPPLY
WIRE (6) to the RIBBED (or WHITE) FIXTURE LEAD WIRE (7). Loop the SUPPLY
GROUND WIRE (9) around the GROUND SCREW (15) on the CROSS STRAP (2).
[Note: Be sure to provide an extra 3in. length of the SUPPLY GROUND WIRE (9) for connection
to the FIXTURE GROUND WIRE (8).] Tighten the GROUND SCREW (15). Connect the
remaining SUPPLY GROUND WIRE (9) to the FIXTURE GROUND WIRE (8) using a WIRE
CONNECTOR (10). Push wiring and connections inside the OUTLET BOX (1).
3. Place the COVER PLATE (14) over the FIXTURE SCREWS and HEX NUTS (16).
[Note: Adjustment of CROSS STRAP (2) may be necessary] Secure COVER PLATE (14) with
the DECORATIVE NUTS (11) provided.
4. Remove SOCKET RINGS (13). Slide the GLASS SHADES (12) over the SOCKETS (17) and
secure with the SOCKET RINGS (13).
5. Install bulbs (not included), MAXIMUM 60W each.
INSTALLATION IS NOW COMPLETE
GENERAL
ASSEMBLY AND INSTALLATION
CAUTION
1
2
4
5
6
7
8
9
10
3
15
16