Assembly & Installation Instructions

Turn on the power at fuse or circuit box
Green Grounding
Screw (E)
Headless
screw (D)
Mounting Screw (B)
Wire Nut (C)
Lock Nut (F)
Mounting plate (A)
Ball Nut (G)
The following parts are available for re-order if damaged or missing.
Spare Parts List:
Shade
Diffuser
A: 35-1/2”
B: 9”
C: 9”
A
B
C
2. Attach the mounting plate to the outlet box by using two mounting screws.
3. Pull out the outlet wires and house grounding wire from the outlet box. Make wire connections using the wire
nuts:
---Connect the black wire from the fixture to the black wire from the power source.
---Connect the white wire from the fixture to the white wire from the power source.
---Attach the fixture grounding wire to the mounting strap with the green grounding screw. Then connect it to
the house grounding wire with a wire nut.
Carefully put the wires back into the outlet box.
4. Attach the fixture to the mounting plate by inserting the headless screw, then secure it with the ball nuts.
5. Place the diffuser and the shade onto the socket, then tighten them with socket ring. Adjust the diffuser fully
recessed onto the bottom circle of the shade if necessary.
6. Install the bulbs (not included). See relamping label on socket area or packaging for maximum allowed wattage
.
1.Thread two headless screws through the mounting plate, then secure them with four lock nuts (two on each
side of the mounting plate). Adjust the length of the headless screws if necessary.
Note: Make sure that the headless screws are lined up horizontally, in order to ensure that the fixture will be
level.
Mounting Hardware
(1 SET)