Assembly & Installation Instructions

Turn on the power at fuse or circuit box

Green Grounding

Screw (E)

Headless

screw (D)

Mounting Screw (B)

Wire Nut (C)

Lock Nut (F)

Mounting plate (A)

Ball Nut (G)

The following parts are available for re-order if damaged or missing.

Spare Parts List:

Shade

A: 6”

B: 16”

C: 6-3/4”

2. Attach the mounting plate to the outlet box by using two mounting screws.

3. Place the candle cover onto the socket to cover the socket completly.

8. Install a bulb (not included). See relamping label on socket area or packaging for maximum allowed wattage.

9. Place the shade onto the bulb and allow the clip of the shade to hold the shade.

4. Secure the nipple into the fixture light untill tightened.

5. Attach the tube to the fixture by inserting the nipple, then secure it with the finial.

6. Pull out the outlet wires and house grounding wire from the outlet box. Make wire connections using the wire

nuts:

---Connect the black wire from the fixture to the black wire from the power source.

---Connect the white wire from the fixture to the white wire from the power source.

---Attach the fixture grounding wire to the mounting strap with the green grounding screw.

Then connect it to

the house grounding wire with a wire nut.

Carefully put the wires back into the outlet box.

7. Attach the fixture to the mounting plate by inserting the headless screw, then secure it with the ball nuts.

1. Thread two headless screws through the mounting plate, then secure them with four lock nuts (two on each side of the

mounting plate). Adjust the length of the headless screws if necessary.

Note: Make sure that the headless screws are lined up horizontally, in order to ensure that the fixture will be level.

Mounting Hardware

(1 SET)