Installation Guide

2of2
FINISH: ANTIQUE WHITE
NOTE: ALL DIMENSIONS ARE ROUNDED UP TO THE NEAREST 1/4"
Nipple
Fixture
Loop
Supply
Wires and
Ground Wire
Canopy
Chain Loop
Canopy
Lock Ring
C
B
D
C
Suggested chain length for
Ceiling height :
8’ ceiling : use 8links of
chain and 2 quick links
9’ ceiling : use 18links of
chain and 2 quick links
10’ ceiling : use 28 links of
chain and 2 quick links
Figure 3
STEP 4 - Making the Wire Connections
A. Wrap bare or green ground wire around green ground screw on the
crossbar, no less than 2 inches from the end of the wire. Tighten the
green ground screw.
B. Use standard wire connectors (not included) to make all wire
connections. Twist connectors until wires are tightly joined together.
Wrap each connection with approved electrical tape and carefully
stuff all the connected wires into outlet box.
Note: If the electrical wire is going to be cut shorter than provided
you will need to identify the "L" line wire and the "N" neutral wire
before you cut the excess wire off. One is labeled N and the other
labeled L. To do this separate the "L" line wire and the "N" neutral
wire as far as you need to. Re-label the wire near where you want to
make the cut. Be sure to mark the wire on the side of the fixture and
not on the excess wire being cut and removed.
Green Ground Screw
on the Crossbar
White wire
from outlet box
supply wire from fixture
identified with the Label “N”
Black wire from
outlet box (or Red)
supply wire from fixture
identified with the label “L”
Bare, or Green
Ground wire
from outlet box
Ground wire
from Fixture
Figure 4
STEP 5 - Install the Bulbs
A. Insert the bulb onto the socket and screw snugly into place.
Your fixture is now assembled and ready to use. Enjoy!
Bulb(not included)
Figure 5
5” Dia.
1”
28” Dia.
23”
75.5”