Assembly Instructions

(STEP 2)

(STEP 1)

(STEP 3)

CARE INSTRUCTION

~ Be sure to use the same type of polish consistenly.

Your furniture will appear cloudy or streaky if oil

based or wax based polishes are interchanged.

~ Spray your furniture surface evenly. Wipe in a

circular motion with a soft clean cloth.

Hardware List :

ASSEMBLY:

Turn the chair to standing position. Check it's balance and tighten all screw and bolts to complete the assembly.

PAGE 2 OF 2

Chair Back

Seat Frame

1. Position the Chair Back on a soft surface such as a carpet. Place the Seat Frame (Wood seat is pre- attached to the seat frame

in assembly) on to the middle rail of the Chair Back with the dowel fully Inserted into the pre-drilled hole.

1.1. Insert 70mm JCBC Bolt a Lock Washer and a Flat Washer into the pre- drilled holes on the rear corner block of the seat frame.

1.2. Insert the 40mm JCBC Bolt a Lock Washer and a Flat Washer through the rear pre-drilled holes on the seat frame.

Assemble front leg as shown

2. Insert the 70mm JCBC Bolt through a Lock Washer, a Flat Washer and the pre-drilled holes of Corner Block into the pre-drilled

holes on the Front Leg, use the provided Allen Key. But do not fully tighten the bolts yet.

SIDE CHAIR

JCBC Bolt

2 pcs

M6x40mm

JCBC Bolt

8 pcs

M6x70mm

Lock Washer

10 pcs

M6x13mm

Flat Washer

10 pcs

M6.5x16.5mm

Allen Key

1 pce

70mm

40mm

(Fig.1.1)

(Fig.1.2)

(Fig.2.1)