Installation & Assembly

1A
Install the Fixture
Secure the mounting plate to the junction box.
Install the candle tubes by slipping them over the sockets.
Screw the lamps into the sockets. Refer to the label on the lamp socket for Max Wattage information.
Feed the cord through the column and fixture loop, then screw the column onto the fixture.
Determine the wanted height of the fixture and remove a portion of the chain by opening a link with pliers.
Install a quick link onto both ends of the chain and install one quick link onto the fixture loop.
Install the other quick link onto the canopy loop to secure the fixture.
Weave the cord through the chain, canopy, and out of the junction box. Trim the cord leaving enough to make
electrical connections.
Connect the fixture to a suitable ground in accordance to local electrical codes.
Connect the white fixture wire (square and/or rigid) to the neutral power line wire with a wire nut.
Connect the black fixture wire (round and/or smooth) to the hot power line wire with a wire nut.
Neatly place all the wires into the junction box, place the canopy onto the mounting plate studs, and secure it in
place by screwing the cap nuts onto the studs.
1
2
3
4
5
6
7
8
9
10
11
JUNCTION BOX
CANOPY
FIXTURE LOOP
CHAIN
CAP NUT
MOUNTING PLATE
LAMP
SOCKET
2
12
11
CANDLE TUBE
MOUNTING
PLATE STUD
COLUMN
FIXTURE
QUICK LINK
3
10
CANOPY LOOP
12
4
2