Assembling & Installation Instructions
WARNING! SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER.
ATTENTION! COUPER LE COURANT AU FUSIBLE OU UN DISJONCTEUR.
including the single bar.
2. Carefully unpack your new fixture and lay out all the parts on a clear
area. Take care not to lose any small parts necessary for installation.
3. Put the candle sleeve(G) over the lamp holder.
4. Install the light bulbs (No Included) in accordance with the fixture's
specifications. NOTE: DO NOT EXCEED THE MAXIMUM
WATTAGE RATING!
6. Attach the assembly lamp body onto the post (F, no included) and
lock it securely with the screws (E).
Your installation is now complete. Return power to the junction
box and test the fixture.
Fixture
GroundWire
A
FIXTURE
WIRES
Black or
Smooth
HOUSE
WIRES
Black(Hot)
FIXTURE
WIRES
White or
Ribbed
FIXTURE
WIRES
Bare
Copper
(Ground)
HOUSE
WIRES
White
(Neutral)
HOUSE
WIRES
Green or Bare
Copper(Ground)
FIG.2
FIG.1
ASSEMBLING & INSTALLATION INSTRUCTIONS
The drawing shown may not exactly match the product enclosed.
However, the installation instructions do apply to this product.
Thank you for purchasing our product.
Need assistance with parts or assembly? Please call customer service
ALL RIGHTS RESERVED
ASSEMBLING THE FIXTURE (Fig.1)
1. Shut off the power at the circuit breaker and remove old fixture,
CONNECTING THE WIRES (Fig.2)
1. Connect the electrical wires as follows. Connect the Black wire from
5. Attach the pipe thread(C) into the shade of the lamp
body(D), aligning the box top center screw hole with the pipe thread,
by turning it clockwise until tight. Attach the cove (B) to the lamp
body(D), then lock it securely with the loop(A).
the fixture to the black house (hot) Wire. Connect the white wire from
the fixture to the white (neutral) house wire. Make sure all wire nuts
are secured. You may wrap the connections with electrical tape. If
your outlet box has a ground wires (green or bare copper) connect
fixture’s ground wire to it. Otherwise attach the bare copper fixture
wire to the green ground screw on the mounting plate.
2. Tuck the wire connections neatly into the post.