ASSEMBLY INSTRUCTIONS Description : X-BACK STOOL Printed in Vietnam -1-
BEFORE ASSEMBLY Thank you for purchasing this quality product. This product has been designed for easy assembly and constructed for durability. All parts were checked prior to packaging to insure quality. Prior to beginning assembly, however, make sure all parts and hardware are included and free of obvious defect. If a part is missing or defective, please contact the store where purchased.
HARDWARE LIST When unpacking, please be careful not to discard any parts with the packaging. Before continuing, please make sure you have all of the following hardware: NO Description Qty Sketch NO Short bolt 1 2 (M6x40mm) Sketch 4 (M6x60mm) Long bolt Flat Washer 4 4 11 (6.5x19mm) (M6x80mm) Screw Lock Washer 5 Qty Medium bolt 3 3 Description 11 6 (6.
STEP 2 Attach front legs (E) to the seat frame with bolts (2), washers (4) and (5). Tighten with allen key (7). Attach front stretcher (D) and side stretchers (C) to front and back legs with screws (6) as shown below. Tighten with a screwdriver. STEP 3 Attach the seat (F) to top of the seat frame (from Step 2) with screws (6). Tighten with a screwdriver.
