Installation Instructions

ManualsBrandsThree Posts ManualsLantern Outdoor Wall LightingMayhugh Chelesa Bronze 4 - Bulb 6.13" H Outdoor Wall Lantern

INSTALLATION INSTRUCTIONS

WARNING! SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER.

AVERTISSEMENT! COUPER LE COURANT AU NIVEAU DES FUSIBLES OU DU DISJONCTEUR.

MOUNTING THE FIXTURE (Fig.1)

1. Shut off power at the circuit breaker and remove the old

fixture, including the mounting hardware.

2. Carefully unpack your new fixture and lay out all the parts on

a clear area. Take care not to lose any parts necessary for

installation.

4. Align the curved end of scroll arm (R) through the decorative

ring (T), secure the other end to the backplate (U) with screw

(Q) (Size:M4*10) and hex nut and gasket washer (P).

CONNECTING ELECTRICAL (Fig.2)

5. Connect the electrical wires as shown in (Fig.2), making

sure that all wire connectors are secured. If your outlet has a

ground wire (green or bare copper), connect the fixture

ground wire to it. Otherwise, connect the fixture ground wire

directly to the mounting plate using the green screw

provided.

6. Align the fixture to the mounting screw(S) (Size:8-32*1/2”)

on the mounting plate (M) and secure with knurled knobs (B)

and washers(K)(Fig1).

7. To prevent moisture from entering the outlet box and

causing a short, use clear caulking (i.e. Indoor/Outdoor

Silicone Sealant) to outline the outside off fixture back-plate

where it meets the wall leaving a space at bottom to allow

moisture a means to escape (Fig3).

COMPLETING THE INSTALLATION

8. Place candle sleeves (V) over the sockets (W).

9. Install 60W /type B bulbs (D) (not included) in accordance

with the fixtures specification

. (DO NOT EXCEED THE

MAXIMUM WATTAGE RATING!)

(NE PAS

DEPASSER LA PUISSANCE NOMINALE MAXIMALE!)

10. Separate lamp body (O) from top cover (H) by unscrewing

the mounting screws (G) ( Size: M4*16). Align the glass (E)

into body (O) and secure with glass clips (F).

11. Re-attach body (O) to the top cover (H) with mounting

screws (G).

Your installation is now complete. Return power to the junction

box and test the fixture.

Fig.3

Fig.1

IMPORTANT: FIXTURE SHOULD BE INSTALLED BY A

QUALIFIED ELECTRICIAN TO ENSURE PROPER WIRING

AND INSTALLATION.

ATTENTION – RISQUE D’INCENDIE, CONSULTER UN

ÉLECTRICIEN QUALIFIÉ POUR VOUS ASSURER QUE LES

CONDUCTEURS DE LA DÉRIVATION SONT ADÉQUATS.

Candle Cover

READ AND SAVE THESE INSTRUCTIONS

Mounting plate (1)

Ground screw (1)

Mountin

g screws (2)

3. Attach the mounting plate(M) to the outlet box(not

provided) with the two screws(C) (Size:8-32*1/2”).