Installation & Assembly

Step 2
Step 3
Step 4
Place the Backrest(A) faceup on the floor, then slide the Seat(B) into the housing.
You will see 6 ( six ) attachment points.
Attach the Seat(B) to Backrest (A) with the M8 Bolt(1) + Spring Washer Ring(3) + Flat Washer
Ring(2) as shown.
Use the Allen Key(5) to fasten all six bolts.
Install the Legs (C) onto the Seat (B) and Backrest (A) by putting a Washer Rings (4) (optional but
improve security and tightness) onto the theaded stem.
Insert the threaded stem into the mounting position at each corner of the bottom of the Loveseat.
Tighten the leg by turning clockwise.
Repeat the same steps to install the remaining three legs.
On completion of fixing the four legs to the base of the Seat(B), reseal the non-woven cover back to
its original condition.
Seat(B)
Backrest (A)
Seat(B)
Backrest (A)