Assembly Instructions

Step 3
Install the Legs (C) onto the Seat (B) and Backrest (A) by putting Washer Rings (4) and Plastic
gasket(6)(optional but improve security and tightness) onto the theaded stem.
Insert the threaded stem into the mounting position at each corner of the bottom of the Loveseat.
Tighten the leg by turning clockwise.
Repeat the same steps to install the remaining three legs.
Step 4
Turn the Seat(B) upside down (preferrably on a surface that won't scratch the upholstery).
Remove the non-woven fabric from under the Seat(B).
Take out the four Legs(C) and the bag containing Hardwares.
Step 2
Place the Backrest(A) faceup on the floor, then slide the Seat(B) into the housing.
You will see 6 ( six ) attachment points.
Attach the Seat(B) to Backrest (A) with the M8 Bolt(1) + Spring Washer Ring(3) + Flat Washer Ring(2)
as shown.
Use the Allen Key(5) to fasten all six bolts.
Backrest
(A)
Seat(B)
3 of 5