Installation & Assembly

ASSEMBLING & INSTALLATION INSTRUCTIONS
The drawing shown may not exactly match the product enclosed. However, the
installation instructions do apply to this product.
 WARNING! SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER.
 ATTENTION! COUPER LE COURANT AU FUSIBLE OU UN DISJONCTEUR.
ASSEMBLING THE FIXTURE (Fig.1)
1. Shut off the power at the circuit breaker and remove old fixture, including the
single bar. Carefully unpack your new fixture and lay out all the parts on a
clear area. Take care not to lose any small parts necessary for installation.
2. Attach the mounting screw part way into the side hole of the crook cross bar,
then lock it securely with hex nut until becoming. Attach the cross bar to the
junction box using two box screws. The side of the cross bar marked “GND”
must face out.
3. Follow wiring instructions carefully (see fig.2).
4. Using the end of arm(A) hook the lamp body's loop, aligning the end hole of
the arm(A) with the top hole of back plate, lock it securely with screw(E) and
hex nut. Put the candle sleeve(D) over the lamp holder.
5. Attach the back plate of the lamp body(B) onto the junction box, aligning
screws on cross bar with mounting holes and lock it securely with the ball
nuts(C).
6. Install the light bulbs(Not included) in accordance with the fixture’s
specifications. NOTE: DO NOT EXCEED THE MAXIMUM WATTAGE
RATING!
7. With silicone caulking compound, caulk completely around where back
of cover meets with the wall surface to prevent water from seeping into
junction box.
CONNECTING THE WIRES (Fig.2)
1. Connect the electrical wires as follows. Connect the Black wire from the fixture
to the black house (hot) Wire. Connect the white wire from the fixture to the
white (neutral) house wire. Make sure all wire nuts are secured. You may wrap
the connections with electrical tape. If your outlet box has a ground wires (green
or bare copper) connect fixture’s ground wire to it. Otherwise attach the bare
copper fixture wire to the green ground screw on the mounting plate.
2. Tuck the wire connections neatly into the wall junction box.
Your installation is now complete. Return power to the junction
box and test the fixture.
FIXTURE
WIRES
Black or
Smooth
HOUSE
WIRES
Black(Hot)
FIXTURE
WIRES
White or
Ribbed
FIXTURE
WIRES
Bare
Copper
(Ground)
HOUSE
WIRES
White
(Neutral)
HOUSE
WIRES
Green or Bare
Copper(Ground)
FIG.2
FIG.1