Installation And Safety Instructions

IMPORTANT: DO NOT ATTACH FIXTURE DIRECTLY TO OUTLET BOX

ITHOUT THE USE OF A MOUNTING BAR.

A. Use an orange listed wire connector to connect the 18AWG fixture

hot wire (black wire, or round and smooth tracer) to the supply hot wire.

B. Use an orange listed wire connector to connect the 18AWG

fixture common wire (white wire, or square and rigid) to the supply

common wire.

C. Gently try to remove the wires from the connector. If you can

remove the wires, carefully re-do the wiring connection.

GROUNDING INSTRUCTIONS

Connect the supply ground wire, fixture ground wire, and mounting bar

ground wire (pre attached) using the supplied wiring connector. Gently try

to remove the wires from the connector. If you can remove the wires,

carefully re-do the wiring connection.

fter wires are connected, tuck them carefully inside the outlet box.

Position backplate (D) over fixture mounting screws (A) and secure in

by threading cap nuts (E) onto fixture mounting screws (A).

Make sure no bare wires can be seen outside wire connectors.

NOTE: IF GLASS PANELS ARE NOT INSTALLED, PLEASE

OLLOW THIS STEP: PLACE BOTTOM EDGE OF GLASS INTO

CHANNEL. BEND TABS OVER EDGE TO SECURE IN PLACE.

nstall lamps.

STEP 1:

STEP 2:

STEP 3:

STEP 4:

NOTE FOR FIXTURES THAT ARE SOLID BRASS:

Your handcrafted, solid brass lighting fixture has been coated with a

durable, baked on acrylic lacquer which gives maximum protection

against the weather. In time, however, the brightness of the brass

will tarnish giving way to an authentic old world brass finish.

NOTE: To keep your solid polished brass fixture looking new for

years to come, regularly apply a good quality non-abrasive car wax

to all metal surfaces, giving the fixture an extra protective coating.

nsert fixture mounting screws (A) in threaded holes of universal

mounting plate (B). Run fixture mounting screws (A) all the way down

to the heads.

STEP 1:

lace universal mounting plate (B) against outlet box (not supplied)

and screw in place using #8-32 outlet box screws (not supplied). Be

sure the mounting screws (A) are perfectly horizontal so fixture hangs

straight.

STEP 2:

INSTALLATION FINAL ASSEMBLY