Assembly and Installation Instructions

Lock Nut (E)
WARNING:
TO AVOID RISK OF ELECTRICAL SHOCK, BE SURE TO SHUT OFF
POWER BEFORE INSTALLING OR SERVICING THIS FIXTURE.
NOTES: 1. Before installing, consult local electrical codes for wiring and grounding requirements.
2. Read and save these instructions.
1.
Thread two fixture mounting screws through the mounting plate, and then secure them with two lock nuts. Adjust
the length of the fixture mounting screws if necessary.
Note: Make sure that the fixture mounting screws are lined up horizontally to make the fixture level.
2. Attach mounting plate to the outlet box using two mounting screws.
3. Pull out the source wires from the outlet box. Make wire connections using wire nuts as follows:
---Connect the hot wire (usually black insulation) from the fixture to the black wire from the power source.
---Connect the neutral wire (usually white insulation) from the fixture to the white wire from the power source.
---Attach the fixture grounding wire (usually green insulation or bare wire) to mounting plate with the green
grounding screw, and then connect it to the house grounding wire with the wire nut.
Carefully put the wires back into the outlet box.
ASSEMBLY AND INSTALLATION
INSTRUCTIONS
Mounting Screw (B)
Wire Nut (F)
Ball Nut (G)
Bulb Type A Max.60W
(not included)
Hardware Package (included):
Fixture Mounting
Screw (D)
Green Grounding
Screw (C)
Turn off the power at fuse or circuit box.
Installation Steps
Mounting Screw (B)
Mounting Plate (A)
Green Grounding Screw (C)
Wire Nut (F)
Back Plate
Ball Nut(G)
House Grounding Wire
Fixture Grounding Wire
Fixture mounting
Screw(D)
Lock Nut(E)
Outlet Box
Fixture Wire
Mounting Plate (A)

Summary of content (2 pages)