Owner's Manual

For communication over RS-232 the appropriate baud rate will need to be set, otherwise USB should be selected.
Select Edit to highlight the baud rate and use the up and down arrows to adjust.
System
→ Diag: Meter Diagnostics
The diagnostics section consists of five screens that detail system operation and overall performance. The
information provided in the diagnostics section is intended for troubleshooting and/or repair.
System
→ Checking GPS Information in the Diag Menu Serial Numbers 1521 and above
1. Make sure GPS logging is enabled: (Run → Setup)
2. Go back to home screen, press System → Diag, then navigation to screen 5
a. Location is given in latitude and longitude
b. DOP: degrees of precision
c. N Sat: number of satellite signals detected