Owner's Manual

From the main menu select System.
Select Setup to make adjustments to basic meter functions and Diag to view system diagnostics.
System
→ Setup: Time Stamp
Since a time stamp is recorded with each data point it is important to maintain the correct date and time. Select
Edit to highlight the hour and use the up and down arrows to adjust setting. Use the right arrow button to advance
to minutes, seconds, months, and so forth. Select Enter when set.
System → Setup: Operational Functions Serial Numbers 1521 and above
By default, the MC-100 will beep every time a key is pressed, in addition to a four minute auto-off feature to help
conserve battery power. To turn these features off, select Edit to highlight the Key press beep. Pressing the up and
down arrows will toggle between Yes and No. Use the right arrow to advance to the next setting.
System → Setup: Operational Functions Serial Numbers 1-1520
By default, the MC-100 will beep every time a key is pressed, in addition to a four minute auto-off feature to help
conserve battery power. To turn these features off, select Edit to highlight the Key press beep. Pressing the up and
down arrows will toggle between Yes and No. Use the right arrow to advance to the next setting.
A specific GPS baud rate is required when communicating with a compatible GPS device. Contact Apogee
Instruments technical support for more information on connecting to a GPS device.
System
→ Setup: Baud Rate Output Serial Numbers 1521 and above
This setup option is no longer available.
System → Setup: Baud Rate Output Serial Numbers 1-1520
System settings
and diagnostics
Setup
Back
Diag
24Hr Time
[00:00:00]
Date
[01/01/2015]
Format
[MM/DD/YYYY]
Exit
Edit
Key press beep
[Off]
Auto power Off
[Off]
GPS Baud rate
[ 4800]
Exit
Edit
Serial port output
Baud rate [ USB ]
Exit
Edit
Key press beep
[Off]
Auto power Off
[Off]
Exit
Edit