Technical Specifications

White Elastomeric Roof Patch
100% Acrylic Elastomeric Polymers for Long Lasting Flexibility
Revised: 11/15
Manufacturer:
ThorWorks Industries, Inc.
2520 S. Campbell St.
Sandusky, OH 44870
Phone: [phone]
Fax: [phone]
Description
White Elastomeric Roof Patch is a 100% acrylic
elastomeric emulsion patch material designed for
a variety of roof repairs including cracks, seams,
skylights, vents, and metal joints. Dries white.
Uses
A variety of roof surfaces including metal, mobile
homes, aged aluminum roof coatings, concrete,
campers/RV’s, and more.
Surface Preparation
Sweep off all dirt, dust, and debris. Remove rust,
mildew, oil, grease, or other foreign material
on the surface. Scrub roof with solution of TSP
(Trisodium Phosphate) and water. Remove mold
and mildew with bleach solution (1 part chlorine
bleach and 3 parts water). Rinse thoroughly and
allow to dry.
Application
Stir pail thoroughly. With a 4-inch wide paint
brush, apply a liberal amount of Elastomeric Roof
Patch. Apply Roof Patch 6-inches wide along
cracks, seams, or vent areas. Roll Reinforcing
Fabric into wet roof patch. Smooth out fabric
with paint brush. While material is still wet, brush
another coat of Roof Patch over the Reinforcing
Fabric. Make certain the fabric is completely
embedded into Roof Patch material. Allow Roof
Patch material to dry thoroughly before applying
White Elastomeric Roof Coating.
Drying Time
Depends on thickness of application.
Clean Up
Wash tools with water before material dries.
Weather Conditions
Application temperature must be a minimum of
60°F and rising. Do not apply when temperature
is expected to drop below 60°F within a 24 hour
period. Be sure to wear eye protection when
working with this product. In areas where dew or
fog accumulates in the early evening, it is best
to apply in the morning. Stop applying by early
afternoon (3:00 pm) to prevent wash off, which
will occur if dew, fog, or rain arrive before material
dries. Do not apply if rain is imminent or forecast
within 24 hours of application.
Coverage (Approximate)
Dependent upon depth and width of areas to be
repaired.
Precautions
• Do Not Freeze
• Do Not Store at Temperatures Below 50 ºF
Safety And Environmental Precautions
• Refer To Material Safety Data Sheet Before Using
• For Exterior Application Only
• Close Container When Not in Use
• Environmental Information is on the Material
Safety Data Sheet
• Do Not Reuse Empty Container
• Volatile Organic Content (VOC) is 100 gm/liter
max
• KEEP OUT OF REACH OF CHILDREN
Ingredients: Cas No.
Water 7732-18-5
100% acrylic emulsion polymer (proprietary)
Limestone 16389-88-1
Titanium Dioxide 13463-67-7
Ester Alcohol 25265-77-4
www.sealbest.com