Technical Specifications

Cold Process
Blind Nail & Lap Adhesive
A Waterproof Adhesive for Use in the Application of Roll Roofing
Revised: 11/15
Manufacturer:
ThorWorks Industries, Inc.
2520 S. Campbell St.
Sandusky, OH 44870
Phone: [phone]
Fax: [phone]
Description
A professional grade material made from special
adhesive asphalts, non-asbestos fibers, special
resins and other ingredients that assure its rapid
and tight fusion to the base surface. Intended
primarily as a blind nailing cement for use with
roll roofing. It creates a tight bond and prevents
buckling and curling of edges. Also suitable
for application to older roofs to seal cracks and
pinholes.
Uses
• Adhesive for Rolled Roofing
• Bonds a Variety of Cold Process
Roofing Membranes
• Brush Grade
Surface Preparation
Clean surface with brush or broom, removing all
loose sediment and dirt. Nail down any loose parts.
Application
Apply with a roofer’s brush or a masonry trowel
in a uniform consistency. Apply a sufficient
amount of adhesive to cover the entire underside
of the membrane and to allow a 1/8” - 1/4” bead
of adhesive to form along the lap seam when
membrane is pressed into place. Broom or walk
the overlying sheet firmly into the cement and
smooth it out to prevent buckles or blisters. Do
not apply if rain is imminent within 24 hours of
application. Clean tools with mineral spirits or
kerosene in a well ventilated area immediately
after use.
Drying Time
Allow 24 hours depending on weather conditions.
Clean Up
While wet, use soap and water.
Weather Conditions
• Do not apply if rain is imminent or forecast
within 24 hours of application.
Coverage (Approximate)
50 square feet per gallon,
150-175 Linear feet/4 inch Lap
Precautions
• Do Not Freeze
• Do Not Store at Temperatures Below 50 ºF
• CAUTION! COMBUSTIBLE
Do not heat or thin! Apply in a well ventilated
area. Do not use where hydrostatic pressures
may be encountered. Do not store container at
temperatures above 100 ºF. Do not apply over coal
tar surfaces.
IF MATERIAL APPEARS TOO STIFF DURING COLD
WEATHER, KEEP IN WARM AREA BEFORE USING.
KEEP CONTAINER TIGHTLY CLOSED WHEN NOT IN
USE. STIR BEFORE AND DURING USE
Safety And Environmental Precautions
• Refer to Material Safety Data Sheet Before Using
• For Exterior Application Only
• Close Container When Not in Use
• Environmental Information is on the Material
Safety Data Sheet
• Do Not Reuse Empty Container
• CONTAINER MAY BE HAZARDOUS WHEN EMPTY
as container may contain product residues and/
or combustible vapors. All labeled hazardous
precautions must be observed. Dispose of empty
container in accordance with local, state or federal
regulations.
• Volatile Organic Content (VOC) is 300 gm/liter
max
• KEEP OUT OF REACH OF CHILDREN
Ingredients: Cas No.
Petroleum Asphalt
Mineral Spirits
Calcium Carbonate
Magnesium Carbonate
Cellulose
Amine Salt
8052-42-4
64742-88-7
1317-65-3
546-93-0
9004-34-6
Not Est’d
www.sealbest.com