Product Manual

VENDOR TO REMOVE AREA BELOW DASHED LINE AFTER PRINTING
B20460 ECN-15100 (1007)
VENDOR TO REMOVE AREA BELOW DASHED LINE AFTER PRINTING
B20460 ECN-15100 (1007)
3 10
Safety Guidelines
This manual contains information that is very important to know and understand. This
information is provided for SAFETY and to PREVENT EQUIPMENT PROBLEMS.
To help recognize this information, observe the following symbols.
Danger indicates an imminently hazardous situation which,
if not avoided, will result in death or serious injury.
Warning indicates a potentially hazardous situation which,
if not avoided, MAY result in minor or moderate injury.
Caution indicates a potentially hazardous situation which, if
not avoided, MAY result in minor or moderate injury.
NOTE:
Note indicates important information that if not followed, may cause damage to
equipment.
Read and understand instructions before use!
Retain this information for future reference.
FOR YOUR SAFETY!
If you smell gas:
1. Shut off gas to the device.
2. Extinguish any open flame.
3. Check the device for leaks using soapy water.
4. DO NOT attempt to relight the device until all leaks are repaired and there is
no gas smell.
DO NOT use this device in areas where gasoline or other liquids having flam-
mable vapors are stored or used.
• Never store a torch that is still hot.
Maintenance
Prior to each use:
1. Inspect all components of the device for damage, excessive abrasion or wear.
If the hose is cut or is more than 5 years old, it must be replaced prior to
operation.
2. Verify that all connections are tight. The nozzle stem assembly should not
swivel or rotate where attached to the Turbo Blast Valve Trigger, tighten any
loose joints.
3. Inspect LP gas tank for dents, damage to collar, damage to shut-off valve
or corroded foot ring. If dents, damage to collar, damage to shut-off valve or
corroded foot ring are present, the LP gas tank must be replaced prior to
operation.
4. Perform a leak test following instructions on page 7.
5. Ignite the torch according to lighting instructions. Check operation of
adjusting valve and all other components prior to proceeding.
Periodically:
1. Remove any debris or combustible materials from torch. The torch must be
kept clear and free of combustible materials.
2. The surface of the device should be cleaned with soap and water. Do not use
petroleum based or flammable cleaner on any part of the device.
•
If the hose is damaged it can create leakage that could result in a fire hazard.
•
If the nozzle stem assembly swivels it will allow leakage that could result in a
fire hazard.
• If the tank is damaged it could rupture resulting in personal injury and/or
property damage.
PAGE 3 OF 12 PAGE 10 OF 12