User's Manual

4
TERMINAL DESCRIPTION
No.
Type
Name
Terminal Description
1
10mm hex
bolt
BATT+
Battery positive. PowerMon-5S takes its power from this
terminal. It also measures the voltage at this point.
2
¼” blade male
terminal
BATT-
Battery negative. Usually also the chassis ground. Connect
using the supplied black wire.
3
10mm hex
bolt
LOAD
Connect to the loads / charger / solar charge controller
4
¼” blade male
terminal
RELAY
Relay output. It drives a mechanical or solid-state relay. This
terminal is connected to ground internally by the device
when the power is turned ON from the app. Use the
supplied blue wire to connect.
5
connector
MF
Multifunction connector. Can be used to connect an
external temperature sensor or external pushbutton.
1
2
3
4
5