BUILT-IN OVEN MODEL MS 60 OPERATING AND INSTALLATION MANUAL 2
Important Safety Information These warnings are provided in the interest of safety. You MUST read them carefully before installing or using the appliance. Your safety is of paramount importance. If you are unsure about any of the meanings of these WARNINGS, contact the Customer Care Department Installation • The oven must be installed according to the instructions supplied. Any electrical work must be undertaken by a qualified electrician/competent person.
Contents For the User For the Installer Important safety information Technical Data Page 20 Page 3 Electrical Connection Page 20 Description of the appliance Page 5 Installation Page 21 Controls Page 6 Before the First Use Page 7 Using the Fan Oven Page 7 Cooking Chart Page 9 Defrosting Page 11 Oven Door Protection Device Grilling Page 12 Cleaning the Oven Page 13 All our appliances comply with the European safety standards.
Description of the Appliance Thermostat Control Light 11 12 Oven Function Control Knob Thermostat Control Knob 1 2 10 0 START 3 8 4 7 6 CLOCK 5 COOKING TIME Grill Element Oven Light Fan Rating Plate Removable handle Grill Pan Grid Grill / Roasting pan Anti-tip shelf (x 2) 5
Controls OFF Oven Function Control Knob Oven Light - The oven light would be on without any heat. Defrost Setting - This setting is intended to assist in thawing of frozen food (see page 13). 0 Oven Light Grill Fan ducted cooking - This allows you to roast or roast and bake simoultaneously using any shelf, without flavour transference. Grill - The heat comes only from the top element.
Before the First Use Remove all packaging, both inside and outside the oven, before using the appliance. Before first use, the oven should be heated without food. During this time, an unpleasant odour may be emitted. This is quite normal. ☞ 1. Switch the oven function control knob to fan cooking . 2. Set the thermostat control knob to MAX. 3. Open a window for ventilation. 4. Allow the oven to run empty for approximately 45 minutes.
The oven has four shelf levels, and is supplied with two anti-tip shelves. It is important that these shelves are correctly positioned as shown in the diagram. 4 3 ☞ How to Use the Fan Oven 2 1. Turn the oven function control knob to . 2. Turn the thermostat control to the required temperature. THINGS TO NOTE • The oven light will come on when the oven function control knob is set. • The oven fan will operate continually during cooking.
Cooking Chart This chart is intended as a guide only. It may be necessary to increase or decrease the temperature to suit your individual requirements. Only experience will enable you to determine the correct setting for your personal requirements.
i Hints and Tips Runner positions are not critical, but make sure the shelves are evenly spread. When cooking more than one dish in the fan oven, place dishes centrally on the shelves rather than several dishes on one shelf. When the oven is full, you may need to allow slightly longer cooking time. A shelf may be placed on the floor of the oven. Place dishes on a shelf in this position rather than on the oven base, to allow air circulation around the food. When the oven is full of the same food, e.g.
Defrosting i Hints and Tips The oven fan operates without heat and circulates the air, at room temperature, inside the oven. This increases the speed of defrosting. However, please note that the temperature of the kitchen will influence the speed of defrosting. This function is particularly suitable for delicate food which could be damaged by heat, e.g. cream filled gateaux, iced cakes, pastries, bread and other yeast products.
Grilling Grilling must be carried out with the oven door closed. The grill pan handle must be removed from the pan. ☞ How to Use the Grill 1. Turn the oven control function knob on COOKING CHART Cooking time depends on the thickness of the meat and not on its weight. Type of food . 2. Turn the thermostat control knob to the required temperature. 3. Adjust the grid and grill pan runner position to allow for different thicknesses of food.
Cleaning the Oven Always switch off at the electricity supply before any cleaning. The oven should be kept clean at all times. A build-up of fats or other foodstuffs could result in a fire, especially in the grill pan. Cleaning materials Before using any cleaning materials on your oven, check that they are suitable and that their use is recommended by the manufacturer. Cleaners that contain bleach should NOT be used as they may dull the surface finishes. Harsh abrasives should also be avoided.
Oven Cavity The enamelled oven cavity is best cleaned whilst the oven is still warm. Wipe the oven over with a soft cloth soaked in warm soapy water after each use. From time to time it will be necessary to do a more thorough cleaning, using a proprietary oven cleaner. If the soilage has become set, after the oven has cooled down, the following process will help to soften the splatters to help make cleaning easier. the grill/ meat pan on the oven shelf ☞ 1. Place positioned in the lowest runner. 2.
Replacing The Oven Light If the oven bulb needs replacing, it must comply with the following specifications: - Electric power: 15W, - Electric rate: 220-240 V (50 Hz), - Resistant to temperatures of 300°C, - Connection type: E14. These bulbs are available from your local Service Force Centre. To replace the faulty bulb: FO 0287 1. Ensure the oven is isolated from the electrical supply. 2. Push in and turn the glass cover anticlockwise. 3. Remove the faulty bulb and replace with the new one. 4.
If something goes wrong If the appliance is not working correctly, please carry out the following checks, before contacting your local Moffat Service Force Centre. SYMPTOM ■ The oven does not come on SOLUTION ◆ Check the oven is in manual operation and that both a cooking function and temperature have been selected. ◆ Check the appliance is wired in properly, and the socket switch or the switch from the mains supply to the oven are ON.
Service and Spare Parts If you require spare parts or an engineer contact your local Service Force Centre by telephoning: 0990-929929 When booking a service call we will need to know the model number and date of purchase, together with your name, address, telephone number and a description of the fault. Customer Relations Department For general enquiries concerning your Moffat appliance, contact our Customer Relations Department by letter or telephone as follows: Moffat Customer Care Department P.O.
MOFFAT SERVICE FORCE To contact your local Moffat Service Centre telephone 0990 929929 SCOTLAND ABERDEEN (M05) 8 Cornhill Arcade Cornhill Drive Aberdeen AB2 5UT AUCHTERMUCHY (M03) 33A Burnside Auchtermuchy Fife KY14 7AJ ARGYLL (M67) BLANTYRE (M07) Briar Hill 7 Hill Street, Dunoon Argyll PA23 7AL Unit 5 Block 2 Auchenraith Industrial Estate Rosendale Way Blantyre G72 0NJ DUMFRIES (M01) 93 Irish Street Dumfries Scotland DG1 2PQ DUNDEE (M70) 3-7 Blackness Street Dundee DD1 5LR DUNOON S Gibson 96 Ar
MOFFAT SERVICE FORCE To contact your local Moffat Service Centre telephone 0990 929929 MIDLANDS BIRMINGHAM (M18) BOURNE (M44) 66 Birch Road East, Wyrley Road Industrial Estate Witton Birmingham B67DB Manning Road Ind Estate Pinfold Road Bourne PE10 9HT GLOUCESTER (M23) 134 Eastgate Street Gloucester GL1 1QT HEREFORD (M31) Unit 3 Bank Buildings Cattle Market Hereford HE4 9HX HIGHAM FERRERS (M51) ILKESTON (M43) The Old Barn Westfield Terrace Higham Ferrers NN10 8BB Unit 2 Furnace Road Ilkeston DE7 5E
Technical Data DIMENSIONS OF RECESS Height Width Depth 580 mm. 560-570 mm. 550 mm. DIMENSIONS OF PRODUCT Height Width Depth 594 mm. 594 mm. 559 mm. DIMENSIONS OF THE OVEN CAVITY Height Width Depth Oven capacity 320 mm. 420 mm. 390 mm. 53.2 litres Heating elements rating Oven element Grill element Convection Fan Oven Light 2.17 kW 1.9 kW 30 W 15 W Total Rating (240 V) Total Rating (230/240 V) 2.215 kW 2.
Installation The oven must be installed according to the instructions supplied. Any electrical work must be undertaken by a qualified electrician/competent person, in accordance with existing rules and regulations. It is dangerous to alter the specifications or modify the appliance in any way. Please ensure that when the appliance is installed it is easily accessible for the engineer in the event of a breakdown.
