Owner's Manual

17
Tightening & loosening Sequence: 1, 3, 4, 2, 1, 3, 4, 2 etc.
Finger tighten each screw, and then using an 8mm spanner, tighten each screw by a sixth of a turn
(60°) at a time and in the correct order until they are tight (5 Nm is more than sufficient and this
removes the chance of shearing the screws).
NB. This procedure only applies to the mini-eccentric and the Mercury - NOT to the eccentric we use
on all of our other Rohloff specific models.
2
3
1
4