Daim Ntawv Qhia Tus Neeg Siv

PD1D Piezo Inertia Drive Stage Chapter 3: Overview
Rev A, August 3, 2021 Page 5
3.3. Unpacking
NOTE
Unpack the stage with care. Check the contents for signs of damage. If there is any sign of damage or
missing parts, contact Thorlabs immediately. The lock plate and corresponding M1.4 screws are used
to lock the stage during transportation or storage.
Unlock the upper M1.4 screw indicated by the note card using the included 1.3 mm hex key and remove the note
card before first use. Leave the M1.4 screw loosened during use.
Figure 2 Loosen the lock screws and remove the note cards before use.
3.4. Accessories
The PD1B(/M) and PD1B2(/M) mounting adapters provide a flat surface for mounting the PD1D(/M) stage and offer
8-32 (M4) mounting and 1/4"-20 (M6) mounting features, respectively.
The PD1T(/M) adapter plate features a central 8-32 (M4) tapped hole, both imperial and metric versions have four
4-40 tapped holes spaced for 16 mm cage systems.
The PD1U(/M) adapter plate features four 6-32 and four 8-32 tapped holes (or eight M4 tapped holes) in a cross
pattern. The bottom surface features five #8 (M4) counterbores, providing a convenient means of attaching load to
the stage.
The PD1Z(/M) Z bracket allows a PD1(/M) or PDX1(/M) stage to be mounted on top of the PD1D(/M) stage for an
XYZ configuration.
The PAA101 1.5 m extension cable and T5026 male adapter can be used to extend the drive cable length to 2.5 m.
CAUTION
Do not mount an imperial accessory to a metric stage or a metric accessory to an imperial stage.