Daim Ntawv Qhia Tus Neeg Siv

PD1D Piezo Inertia Drive Stage Chapter 4: Installation
Rev A, August 3, 2021 Page 11
Thorlabs also offers the PD1U(/M) thick mounting adapter plate to provide a convenient means of attaching a load
to PD series stages by five #8 (M4) counterbores. As shown in Figure 8:
1. Use the five #8 (M4) counterbores to mount the load from the underside of the adapter. Notice that the load
should not cover the two 2-56 (M2) cap screw counterbores on the top surface.
2. Insert two Ø2 mm, 3 mm long dowel pins into the moving platform’s two slots along the travel direction.
3. Mount the adapter plate to the stage by aligning the two dowel pins.
4. Insert two 2-56 (M2), 8 mm long cap screws through the adapter plate to the stage.
Figure 8 Mounting PD1U(/M) Adapter on Moving Platform
2-56 (M2) Cap Screw,
8 mm Long
Ø2 mm Dowel Pin,
3 mm Long
#8 (M4) counterbores