Instruction Manual

Information Leaflet
INF0164T Issue B Aug 2018
LPC09 Ceiling Right-Angle Joint - Fitting Instructions
This leaflet details how to use the LPC09 right-angle joint to fix a custom rail arrangement of the Thorlabs Curtain system.
For the continuing safety of the operators of the equipment and for the protection of the equipment itself, the operator should
take note of the
Warnings, Cautions and Notes throughout this leaflet, and, where applicable, in any associated literature.
1.1 Assembly
1.1.1 Parts Included
Fig. 1.1 Ceiling Right-Angle Joint Plate Kit Parts List
1.1.2 Fitting the Ceiling Right-Angle Joint Plate
1) Insert the half joint plates (B) into the extrusion, one into each side of the 90° joint, and slide to the required position as
shown in Fig. 1.2.
2) Using the four M6 x 16 countersunk bolts (A) provided, attach the right-angle ceiling joint plate (C) to the curtain rail.
3) Using appropriate fixings through the holes highlighted below, attach the bracket to the ceiling.
Fig. 1.2 Fitting the Right-Angle Ceiling Mounting Plate
Caution
Screws or fittings to attach the joint plate to the ceiling are not included. Always choose screws and fittings which
are suitable for use in your ceiling and have enough holding power. If you are uncertain, contact a specialised retailer.
A M6 x 16 Countersunk
Bolt (Qty 4)
B Half Joint Plate (Qty 2)
C Ceiling Right-Angle Joint Plate
Holes for attaching to
the ceiling

Summary of content (2 pages)