User's Manual

19 UNPACKING AND ASSEMBLY
Unpacking and set - up
Take the record player and all accessories out of
the carton. Remove the two transportation locks
(Fig. 1 a/b) by applying lateral pressure. The locks
are located underneath the platter at the front left
and at the rear right.
Place the belt around the sub platter and after-
wards around the motor pulley left of the tonearm
rest. Then put the black platter guide on the axis
and afterwards the glass platter on the sub plat-
ter. It will be automatically centered by the platter
guide (Fig. 2 a-c).
Insert each hinge into the respective recess (Fig.
3 a/b).
Hold the dust cover parallel to the hinges (open-
ing angle approximately 60°), insert and push
as far as it will go. Being in this position the dust
cover may be removed at any time.
Fig. 1 a Fig. 1 b
Fig. 2 a Fig. 2 b Fig. 2 c
Fig. 3 a Fig. 3 b