Manual

7
Temperature Display
The LED display will show the setting temperature when “flash”; Display will show the
temperature for the actual temperature of the cabinet when normal.
(2)There is automatic storage memory when power off in this wine cooler, that means the
setting temperature is memorized automatically even in power off, so the setting
temperature is the same as last setting when the wine cooler is running again.
(3)Defrosting
The unit defrosts automatically.
The evaporator behind the rear wall of the unit defrosts automatically. The condensate
collects in the drainage channel behind the rear wall of the unit, and flows through the
drainage hole into the drip tray by the compressor where it evaporates. When the wine
cooler run for some time, the wine cooler will enter to defrosting, the compressor stop
running and the fan will keep running. The temperature will up to about 5 when
defrosting, then keep on running normally; It takes more time for the temperature to come
up to 5 when the setting temperature is low(for example the setting temperature is -2),
and there are full of wines in the cabinet, and this is not a breakdown.
The switch of interior light is under the control panel to control the light
on or off.
Points Of Intentions
1, The vent grill outside the cabinet is the heat dissipation way of cooling system in wine
cooler, please prevent anything from covering or blocking, or it will make the wine cooler
overheating and cause damage to product.
2, Please prevent blocking cooling fan, or it will make the temperature too high or uneven
in the cabinet.
3, Please close the door tightly, it will cause the refrigerating inefficiency, overflow in the
cabinet, or unnormal temperature once the door is not closed tightly for a long time.
4, Please shut off the power, and open the door to let the cabinet dry enough if you dont
use the wine cooler for a long time.
Product Parameters
1, Voltage: according to local voltage
2, Rated power: 75W
3, Climate type: ST
4, Temperature range in cabinet: 5-20