Instructions Guide

ManualsBrandsThor Kitchen ManualsDomestic AppliancesTHHRG4808U

1 of 7

Ins

INSTALLATION AND SERVICES MUST BE PERFORMED BY A QUALIFIED INSTALLER

IMPORTANT: SAVE INSTRUCTION MANUAL FOR THE LOCAL INSPECTOR’S USE.

READ AND SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE

Determine the combination of top burners that are featured on your range. Identify the parts you need from this

kit to complete the L.P. conversion. When burners are converted from natural to L.P. the BTU ratings are as

follows:

Note: For operation at elevations above 2000ft., appliance rating shall be reduced at the rate of 4% for each 1000 ft. above sea level.

Top Burner

Simmer

burner

Griddle Burner

Oven Burner

Broil Burner

Bypass Jet

BTU

18000B

15000B

12000B

9000BTU

6000BTU

15000BTU

22000BT

14000BT

16500B

13000BT

Orifice Size

1.22mm/

1.24mm

1.07mm

1.0mm

0.8mm

0.72mm

0.34mm/

0.38mm

1.16mm/1.22mm

1.32mm

1.10mm

1.18m

1.05mm

HRG3078U

HRG3080U

HRG3031U

HRG3026U

HRG3609U

HRG3617U

HRG3603U

HRG3618U

HRG4804U

HRG4808U

Instructions for Converting Range to Operate on Liquefied Petroleum Gas

This conversion kit must be installed by a qualified service technician in

accordance with the manufacturer's instructions and all applicable codes and requirements of the

authority having jurisdiction. Failure to follow instructions may result in fire, explosion or

production of carbon monoxide causing property damage, personal injury or loss of life. The

qualified service agency is responsible for the proper installation of this kit. The installation is not

proper and complete until the operation of the converted appliance is checked as specified in the

manufacturer's instructions supplied with this kit.

Before proceeding with the conversion, shut off the gas supply before

disconnecting electrical power to the range. Be sure power supplies are off before installing the

conversion kit. Failure to do so could cause serious bodily injury.

Summary of content (7 pages)

PAGE 1
Ins * 1 of 7 Instructions for Converting Range to Operate on Liquefied Petroleum Gas INSTALLATION AND SERVICES MUST BE PERFORMED BY A QUALIFIED INSTALLER IMPORTANT: SAVE INSTRUCTION MANUAL FOR THE LOCAL INSPECTOR’S USE. READ AND SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE This conversion kit must be installed by a qualified service technician in accordance with the manufacturer's instructions and all applicable codes and requirements of the authority having jurisdiction.
PAGE 2
Instructions for Converting Range to Operate on Liquefied Petroleum Gas IMPORTANT: After replacing the natural gas to LP orifices, be sure to keep the original factory installed natural gas orifices for future range conversion back to natural gas. The factory orifices are marked with the following: Top Burners 1.88mm 18000BTU Top Burners 1.65mm 15000BTU Instructions for Converting Range to Top Burners 1.5mm 12000BTU Top Burners 1.35mm 9000BTU Top Burners 1.10mm 6000BTU Tools Required for L.P.
PAGE 3
of 7 Instructions for Converting Range to Operate on Liquefied Petroleum Gas . 1. Convert the Pressure Regulator For 30 inch with 16,500BTU Broiler and all 36-inch gas range, please follow the below steps: Pull the range away from the cabinet wall. The gas regulator is located at the bottom right corner of the range. a. Electrical shock hazard can occur and result in injury or death. Disconnect electrical power to the range before servicing. Do not remove regulator or allow it to turn during servicing.
PAGE 4
of 7 Instructions for Converting Range to Operate on Liquefied Petroleum Gas 3. Convert Oven Burner Orifice for LP/Propane Gas a. Remove the (2) screws on the bottom of the toe kick panel. Hold the bottom edge of toe kick panel at the middle section and slightly lift towards the front. Hold the toe kick panel on both ends and slowly pull away towards the front. 4. Convert Broil Burner Orifice for LP/Propane Gas For all range except 30 inch with 13,000BTU tube broil, please follow the next steps a.
PAGE 5
of 7 Instructions for Converting Range to Operate on Liquefied Petroleum Gas For 30inch range with 13,000BTU broiler, please follow the converting steps below. 1.Remove the oven door and cooking grid. (See Fig.4a-1 and 4b-1) 2.Unscrew the oven baffle. (See Fig.4c-1) 3.To locate the orifice, hold the broil burner and unscrew the 2 screws that fix it, and move it slightly to to one side. (See Fig.4d-1 and 4e-1) 4.Removing the orifice with an adjustable wrench. (See Fig.4f-1) 5.
PAGE 6
of 7 Instructions for Converting Range to Operate on Liquefied Petroleum Gas 5. Convert Griddle Orifice for LP/Propane Gas 6. Convert Gas Valves for LP/Propane Gas a. Remove control knobs, bezel and control panel b. Using a flat screwdriver, replace gas valve bypass jets with bypass jets for LP (For 36” ranges equipped with 4 top burners and a griddle) a. Remove back guard and back cover (See “Fig. 4a” on previous page) b. Remove the oven burner venturi cover for better access. (See Fig. 5b) c.
PAGE 7
of 7 Instructions for Converting Range to Operate on Liquefied Petroleum Gas 7. Reconnect Gas and Electrical Supply to Range. Leak testing of the appliance shall be conducted according to the installation instructions provided with the range.