Assembly instructions

Table Of Contents

Turn the tabletop over so the bottom is facing up. Place pieces of wood under the drill holes to prevent the coating from cracking

out when drilling. Using a 4mm bit, drill the twelve holes through the pre-punched positions on the underside of the table top.

Turn the tabletop over so the top is facing up. Insert the long wood screws from below through the drill holes in the table top and

attach the assembled unit consisting of the monitor bridge and side panels to the table top.

Screw the rack rails (L) with the help of the supplied wood screws (K) on the inside in parallel to the front edge of the side panels.

We recommend a distance of approx. 1 cm from the front edge.

Installation

studio desk