Assembly instructions

Insert the connector housing and the connecting bolts into the holes provided in the components, as shown in the gure below.
Position all connector housings so that the respective connecting bolts can be completely sunk into the holes and the arrow posi‐
tion of the connector housings points towards the hole.
After insertion, the connecting bolts sit loosely in the drill holes and only spread apart when the connector housings on the associ‐
ated component are tightened.
ö
#
%
&
$
)
'
(
1 Left side panel 6 Upper oor panel
2 Right side panel 7 Base
3 Back panel 8 Front panel
4 Lower oor panel A Connector bolt
5 Middle oor panel B Connector housing
Installation
Thon LP Studio Rack
7