Operation Manual

P6
STARTING UP FOR THE FIRST TIME
3.4 Connecting and using the IR extender
The included IR extender allows you to place the receiver out of sight (e.g. in a closed cabinet)
while still being able to control it. Plug the IR extender into the IR connector on the back of the
receiver. Locate the extender on a position giving it direct sight to the remote control. Once a
suitable location is found, remove the protecting foil from the adhesive tape on the bottom of
the extender and fix it by slightly pressing it down on the surface it should be placed on.
4.0 STARTING UP FOR THE FIRST TIME
Ensure that your satellite signal is of good quality and that all connections are sound. In case
of difficulties or questions, please ask you local dealer for assistance. It is recommended to
follow the Setup Wizard step by step. It will guide you through the basic installation and channel
searching process. You can enjoy digital HD broadcasts within just a few minutes.
4.1 Language selection
After turning on the power for the first time, the language selection menu will appear. Choose
your language with
pq and confirm with OK. A welcome screen will now be displayed. Once
you are ready, press OK to start the wizard. During any stage of the Setup Wizard, you can
press EXIT to get back to the previous screen.
4.2 System Setup
Here you can set the Country, Aspect Ratio, Conversion Mode and Subtitle Language. Use
pq to move the highlight and tu to change settings. To see a list of all possible settings for
the highlighted option, press OK. Once all settings are made, move the highlight to NEXT and
press OK to continue.
4.3 Satellite Selection
Use pq to highlight the satellite your antenna is aimed at and press OK to confirm.
If your antenna is aimed at Astra 19.2° E, select Astra 19.2E. The SCAN MODE screen
will appear.
If your antenna is aimed at HOT BIRD 13° E, select Hotbird 13E.The SCAN MODE screen
will appear.
If your antenna is aimed at another satellite, select OTHER. You will be guided to the Satellite
Settings menu. Refer to chapter 7.1.1 for instructions.
NOTE:
If Germany or Austria is chosen as country and Astra19.2E as satellite, German respectively
Austrian pre-installed channels are available. An extra screen will then be displayed giving a choice between
Preinstalled & Scan and Satellite Scanning. Choose Preinstalled & Scan to install the German respectively
Austrian pre-installed channels and continue with the Setup Wizard as described from point 4.4 or choose
Satellite Scanning to continue without pre-installed channels.
4.4 Scan Mode
Use pq to highlight the desired option and press OK to confirm.
All Will scan all available channels on the chosen satellite.
Free Will scan FTA (Free-To-Air) channels only. This you can choose if not using any decoder
CI module