Operation Manual

YOUR RECEIVER
P3
English
This manual provides complete instructions for installing and using this receiver. The following
symbols will serve as follow.
Warning Indicates warning information.
Tips Indicates any other additional important or helpful information.
MENU Represents a button on the remote control or the receiver
(Bold Character)
Move to Represents a menu item within a window.
(Italic Character)
1.4 Accessories
 User’s Manual
 1 Remote control unit
 IR Extender
 2x Batteries (AAA type)
NOTE:
The batteries should not be recharged, disassembled, electrically short-circuited, be mixed
or used with other types of batteries.
If rechargeable accumulators instead of batteries are going to be used, we recommend using (e.g. NiMH)
types with low self-discharge to ensure long time operation of remote control.
1.5 Usage of external USB devices
It is recommended to use USB 2.0 storage devices. If your device is not compatible to
USB 2.0 specifications, recording, playback and other multimedia functions of the receiver
would not work properly.
THOMSON cannot guarantee compatibility to all types of USB storage devices.
It is advised not to store important information on USB storage devices used with the receiver.
Always make backups of data on your USB storage device before using it with this receiver.
THOMSON will not take responsibility for any loss of information or circumstances caused by
loss of information.
Please ensure that either the USB device is already formatted to FAT/FAT32, or format the USB
device via your receiver, refer to chapter 7.3.3 File Explorer for details.
2.0 YOUR RECEIVER
2.1 DEFAULT PIN-CODE: 0000
2.2 Front Panel
Fig.1
1. Standby/ON switch Turns the receiver ON or to Standby
2. USB connector Connect your USB device (stick, HDD, etc.) to this port
3. 4 digit LED display Displays channel number or time, depending on settings.
4. CI slot Common Interface slot for your decoder module
2.3 Rear Panel
Fig.2
1. SAT IN To connect to the LNB of your satellite antenna for
reception of satellite broadcast signal
2. SAT OUT To loop through the satellite signal to a second receiver
3. AUDIO (L/R) To connect to the audio input of your HIFI or television