Operation Manual

P12
MAIN MENU
7.2.2 Output Options
This is the menu to configure the audio and video outputs of your receiver. Use pq to
highlight the setting you wish to change and
tu to change the value of the highlighted setting.
Press OK for a list with all available options for the chosen setting.
TV Standard: Set the standard corresponding to your TV set. Available options
are: Auto, NTSC, PAL and SECAM.
Aspect Ratio: Use this option to set the aspect ratio of your TV set. Available
options are: 4:3 and 16:9.
Conversion mode: Use this option to set the preferred way of converting 16:9
broadcasts to 4:3 TV format. You can choose between the following
options: Letter-box (the full 16:9 picture will be displayed on your
4:3 TV set with black bars above and below the picture.), Pan and
scan (The centre of the 16:9 picture will be displayed full-screen on
your 4:3 TV) and Combined (Combination of Letter-box and Pan
and scan.)
SCART Mode: Select RGB if your TV is connected to the SCART output or CVBS
in case you use the HDMI output.
Digital Audio: Defines the format available on the S/PDIF output of your receiver.
When set to PCM, the digital output will always output PCM stereo
regardless of the broadcasted audio format. The Auto setting will
pass all incoming digital audio through the digital output. Use this
option if you have your receiver connected to a digital surround
amplifier. The digital output can be switched off by setting Digital
Audio to Off.
Video Format: This setting is only active when the receiver is connected to the
TV set via HDMI. It allows you to set the preferred HDMI screen
resolution. Available options depend from your TV set. (The VF
option can be called directly in viewing mode by pressing VF
button).
Once all settings are made, press EXIT to leave the Output Options menu. A confirmation
banner will be shown. Press OK to save your settings or EXIT to discard.
7.2.3 Time Setting
This menu allows you to set the way the receiver collects and adjusts the time. You can also
adjust the Auto Power Down function here. Use
pq to highlight the setting you wish to
change and
tu or 0~9 to change the value of the highlighted setting. Press OK for a list with
all available options for the chosen setting.
Time Display: Defines when the front panel display will show the clock. Possible
settings are: Off and Stand-by only.
Use GMT: On: the receiver will use broadcast time. Use the Time Zone setting
to define the deviation from GMT time. Summer Time can be set to
On or Off.
Use GMT: Off: Allows you to enter the time settings manually. Use the 0~9
buttons to set the current time in the Local Time option. Use
pq
to move the highlight to Local Date and press OK. A calendar will
be displayed. Use
pqtu to select the actual date and press
GREEN to confirm.