Operation Manual

MAIN MENU
P11
English
7.1.4 Satellite Edit
Here you can edit transponder data or add a new satellite.
On the left of the screen, a list with all available satellites is displayed. The right of the screen
displays a list will all available transponders for the highlighted satellite.
ADDING OR EDITING A TRANSPONDER
Use
pq to highlight the desired satellite. Press u to move the highlight to the transponder
list. Press YELLOW to add a transponder or use
pq to highlight the transponder to be edited
and then press BLUE to enter the edit screen. Use
pq to navigate in the edit screen and use
tu respectively 0~9 to change the settings. Once all settings are made, press GREEN to
save or EXIT to quit without saving.
EDITING AN EXISTING SATELLITE
Use
pq to highlight the satellite you wish to edit. Press BLUE to go to the Satellite Edit
screen. To edit the name of the satellite, use
pq to highlight the name and press OK. A
keyboard will pop up. Use
pq tu to navigate and OK to input the chosen character. Once
finished press GREEN to save the changes or EXIT to quit without saving. To edit the position
of the satellite, use
pq to move the highlight to Position and use the 0~9 buttons to input the
new position. To change the location, use
pq to highlight Location and use tu to change
the location. Possible settings are: East and West. Once all settings are made press GREEN to
save or EXIT to quit without saving.
ADDING A SATELLITE
To add a satellite, make sure the highlight is not in the transponders list (press
t in case of
doubt) and press YELLOW. The procedure for adding a satellite is the same as for editing
a satellite.
7.2 Setup
Use the Setup menu to configure the system settings of your receiver. The following sub-menus
are available: Language, Output Options, Time Setting, Parental Control and OSD Display.
Choose the desired submenu with
pq and press OK to advance.
7.2.1 Language
Here you can set the preferred Display, Audio and Subtitle languages and Country setting.
Use
pq to highlight the setting you wish to change and tu to change the value of the
highlighted setting. Press OK for a list with all available options for the chosen setting.
Display: This setting affects the menu language of your receiver. All menu’s
and messages will be displayed in this language.
Audio: is the preferred audio language. The receiver will automatically
switch audio to the preferred language whenever available.
Subtitle: Whenever available, subtitles will be displayed in the
selected language.
Country: Here you can set your country of residence.
Once all settings are made, press EXIT to leave the Language menu. A confirmation banner will
be shown. Press OK to save your settings or EXIT to discard.