Operation Manual

QUICK GUIDE TO USING YOUR RECEIVER

English

4.5 Signal Adjust

This screen allows you to ﬁne tune the alignment of your antenna for optimum reception.

Use

tu to select the switch input the antenna is connected to. (If the LNB of your antenna is

directly connected to the receiver, choose Switch Input 1) The bars on the bottom of the screen

indicate the current signal strength and quality. A red bar indicates a bad signal. Blue/Green

bars indicate a good signal. Yellow bars indicate that the signal condition is nearly acceptable.

Adjust your antenna for maximum possible signal quality and strength. Once the signal cannot

be improved anymore, ﬁx the antenna on this position and press OK to continue.

4.6 Channel Setup

Your receiver will now perform an automatic channel search. Once the process is ﬁnished, all

found channels will be stored and the receiver will switch to the ﬁrst found channel. You are

now ready to enjoy your new receiver.

NOTE:

If no channels were found during the automatic channel scan, the receiver will display the

“No channel” message. Please refer to chapter 7.1.1 for further instructions.

5.0 QUICK GUIDE TO USING YOUR RECEIVER

We at THOMSON understand that you can’t wait to enjoy your new HD receiver. The following

quick guide will make you familiar with the basic operation of this device. We do, however,

advice you to read the full manual to get the best performance from your THOMSON

HD receiver.

To turn your receiver ON or to Standby, use the STBY button on the remote control or the

button on the left side of the front panel.

Choose the desired channel with the

pq buttons or the P+/P- buttons. Alternatively, you can

digit the channel number with the 0~9 buttons on the remote control. Or press OK in viewing

mode to display the channel list.

The volume can be adjusted with the V+/V- buttons or the

tu buttons.

6.0 OPERATION

In viewing mode, several features are available to make watching TV a true pleasure. This

paragraph describes these features. Please also read chapter 7.0 to get familiar with the menu

of your new receiver.

6.1 Changing channels

Your new receiver is equipped with three ways to change channels.

 via direct access

 via the channel list and

 via the P+/P- or pqkeys.

6.1.1 Direct access

To gain direct access to a certain channel, simply input its number with the 0~9 key’s on the

remote control. Channel numbers can be up to four digits long. Entering a number with less

than four digits is possible. Just wait a few seconds and your receiver will switch to the selected

channel. By pressing OK after entering the channel number receiver will switch to the desired

channel at once.