Operation Manual

CONNECTIONS

English

The diagram inside the battery compartment shows the correct way to install the batteries.

1. Open the cover

2. Install batteries

3. Close the cover

Fig. 4

NOTE:

The batteries should not be recharged, disassembled, electrically short-circuited, be mixed

or used with other types of batteries.

2.6 Using the Remote Control

Fig. 5

To use the remote control, point it towards the front of the digital receiver. The remote control

has a range of up to 7 metres from the receiver at an angle of up to 60 degrees.

The remote control will not operate if its path is blocked.

3.0 CONNECTIONS

3.1 Basic connection with SCART cable

Fig. 6

3.2 Connecting to Satellite Dish

Connecting a ﬁxed satellite dish to your receiver (Fig. 7)

Connecting multiple ﬁxed dishes to your receiver using a DiSEqC 1.0 switch (Fig. 8)

3.3 Connecting USB device to download software and user data

Fig. 9

3.4 Connecting and using the IR extender

The included IR extender allows you to place the receiver out of sight (e.g. in a closed cabinet)

while still being able to control it. Plug the IR extender into the IR connector on the back of the

receiver. Locate the extender on a position giving it direct sight to the remote control. Once a

suitable location is found, remove the protecting foil from the adhesive tape on the back of the

extender and ﬁx it by slightly pressing it down on the surface it should be placed on.

4.0 STARTING UP

Ensure your satellite signal is of good quality. It is recommended that you perform the ﬁrst time

installation following the Installation Wizard step by step. It will help you to easily achieve system

conﬁguration and channel installation.

4.1 Language Selection

Press pq to choose your language, press OK to conﬁrm. The Select Satellite menu will

appear. Future installation steps are depending from satellite where your dish is aimed.

4.2 Select Satellite

a) Your dish is aimed to Astra 1C, 1E, 1F or HOT BIRD satellite.